Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-33 Assembly (Cont'd) Figure 60-80-31 P-56920 Figure 60-80-34 P-61874 Install the other main bearing half into the main bearing caps [Figure 60-80-31] . Figure 60-80-32 P-56921 Measure the bearing journal width at the crankshaft [Figure 60-80-33] & [Figure 60-80-34] . Specifications: Journal Width Std.. . . . . . . . . . . . . . . . .1.417-1.419 inch. (36,0-36,04 mm) Limit for O/S . . . . . . . . . . . . . . . . 1.435 inch. (36,44 mm) P-61875 Install the thrust bearings halves on the main bearing cap [Figure 60-80-32] . Determine the end play for the crankshaft.

Measure the width of the thrust washers/main bearing cap [Figure 60-80-32] . Specifications: Std. End Play. . . . . . . . . . . . . . . . . . . . .0.004-0.012 inch. (0,10-0,30 mm) Use new thrust washers as needed to get the correct end play. 442 Excavator 60-80-10 Service Manual