Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-37 Assembly (Cont'd) Figure 60-80-35 P-61878 Lubricate the thrust washer (with tab) with grease and install them on the main bearing cap [Figure 60-80-37] . P-61876 NOTE: The wear surface of the thrust washer must face the crank web. Install the crankshaft into the engine block [Figure 60-80- 35] . Figure 60-80-38 NOTE: Align the marks on the crankshaft and camshaft. Figure 60-80-36 P-61879 Install the main bearing/thrust washer assembly [Figure 60-80-38] . P-61877 NOTE: The main bearing cap No. 1, at the flywheel end, the chamfer must be towards the flywheel end.

Lubricate the thrust washer (without tab) with grease and install them on the main bearing cap [Figure 60-80-36] . NOTE: The wear surface of the thrust washer must face the crank web. 442 Excavator 60-80-11 Service Manual