RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) If the engine is equipped with balancing shafts use Figure 60-80-41 through Figure 60-80-63. Assembly (Cont'd) Figure 60-80-41 Figure 60-80-39 P-61882 P-61880 Remove the plugs [Figure 60-80-41] . Install the main bearing caps/main bearing assembly [Figure 60-80-39] . Figure 60-80-42 Install the caps in the original locations. Figure 60-80-40 P-61883 Install the balancing shaft [Figure 60-80-42] . P-61881 NOTE: The weights must be positioned toward the oil pan sealing surface. Tighten the main bearing cap bolts as follows [Figure 60- 80-40] : Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Step Angle . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 60° 2nd Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60° 442 Excavator 60-80-12 Service Manual