RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-45 Assembly (Cont'd) Figure 60-80-43 P-61886 Tighten the bolt to 21 ft.-lb. (29 N•m) torque [Figure 60- 80-45] . P-61884 Figure 60-80-46 Turn the adjusting pin in as far as possible [Figure 60- 80-43] . NOTE: The bore of the balancing shaft must align with the crankcase bore. Figure 60-80-44 P-61887 Turn the crankshaft until the #1 cylinder is at TDC [Figure 60-80-46] . NOTE: TDC is reached when the mark on the crankshaft aligns with the centerline of the crankshaft and camshaft [Figure 60-80-46]. P-61885 Install the thrust washer [Figure 60-80-44] . NOTE: Align the thrust washer with the shaft axis.
442 Excavator 60-80-13 Service Manual