Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-77 Assembly (Cont'd) Figure 60-80-75 P-61917 Install the connecting rod cap on the connecting rod. The ends of rod caps must be aligned [Figure 60-80-77] . CD-15560 Figure 60-80-78 Before installing piston/connecting rod assembly, make sure the piston ring gaps are staggered as shown in [Figure 60-80-75] . Install a piston ring compressor on the piston rings. Figure 60-80-76 P-61918 Tighten the connecting rod bolts as follows [Figure 60- 80-78] : Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° 2nd Step Angle . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .30° P-61916 Install the piston/connecting rod assembly in the engine block [Figure 60-80-76] . NOTE: If the connecting rod bolts are still serviceable, do not reuse the bolts more than five times. NOTE: The flywheel symbol on the piston must be toward the flywheel. 442 Excavator 60-80-21 Service Manual