Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-80 Assembly (Cont'd) Figure 60-80-79 P-61939 Install the pulley and bolts [Figure 60-80-80] . Tighten the bolts as follows: P-61919 Initial torque. . . . . . . . . . . . . . . . 29-37 ft.-lb. (40-50 N•m) Check that the connecting rods can be easily moved back and forth on the crank pin [Figure 60-80-79] . First tightening angle: 60 mm long bolts. . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° 80 mm long bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° Install the flywheel. (See Removal And Installation on Page 60-70-1.) Second tightening angle: 60 mm long bolts. . . . . . . . . . . . . . . .

. . . . . . . . . . . . .30° 80 mm long bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° Install the injection pump. (See Fuel Injection Pump Installation on Page 60-50-15.) 442 Excavator 60-80-22 Service Manual