RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-99 Assembly (Cont'd) Figure 60-80-97 P-61956 Tighten the cap nuts to 18-21 ft.-lb. (25-28,5 N•m) torque [Figure 60-80-99] . P-61954 Figure 60-80-100 Install a new seal on the injector lines. Install lines and hand tighten [Figure 60-80-97] . NOTE: Do not rebend the injector lines. Do not reuse the injector lines. Figure 60-80-98 P-61957 Install the fuel return lines through the seal and on the injector [Figure 60-80-100] . NOTE: Do not reuse the fuel return lines. P-61955 Tighten the injector clamp bolts to 12-15 ft.-lb. (16-21 N•m) torque [Figure 60-80-98] . Preload the injector line cap nuts to 4 ft.-lb.
(5 N•m) torque. 442 Excavator 60-80-27 Service Manual