OPERATION Auto Switch With switch (5), the air flow, vents, and air source (RECIRC/FRESH) are automatically selected according to the set temperature. Press switch (5), then use temperature control switch (3) to set the temperature, and run the air conditioner under automatic control. When switching from automatic operation to manual operation, it is possible to use the switches to select the vents and air source (RECIRC/FRESH). Remark When Auto Mode is selected, if the set temperature is set to 18.0°C (64.4°F) and to 32.0°C (89.6°F), the air flow is always set to High, but this is not a problem.
FRESH/RECIRC Selector Switch Switch (6) is used to switch the air source between recirculation of air inside the cab and intake of air from the outside. During automatic operation, the selection of inside air (RECIRC) and outside air (FRESH) is performed automatically. Display Monitor Monitor (7) displays the status of temperature setting (a), air flow (b), and vents (c). When OFF switch (1) is pressed, the display of temperature setting (a) and air flow (b) goes out, and operation stops. 2-96 PC200LC-8 RECIRC Outside air is shut off and only air inside the cab is circulated. Use this setting to perform rapid cooling of the cab or when outside air is dirty.
FRESH Outside air is taken into the cab. Use this setting to take in fresh air when performing demisting.