Komatsu — Checks Before Starting

OPERATION Check Fuel Level, Add Fuel When adding fuel, never spill the fuel or let it overflow. It will cause fire. If any fuel has spilled, wipe it up completely. If fuel has spilled over soil or sand, remove that soil or sand. Fuel is highly flammable and dangerous. Never bring flames near fuel. 1. Turn the engine starting switch to the ON position and check the fuel level gauge (1) on the monitor panel for fuel level. After checking, turn the switch back to the OFF position. 2. If fuel is found to be low, unscrew fuel filler cap (F) on the fuel tank and add fuel through the filler port until float gauge (G) comes up to the highest point. Fuel tank capacity: . . . . . . . . . . . . . . . .

400 liters (105.68 US gal) Position of tip (a) of float gauge (G) when fuel tank is full: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Approximately 50 mm (2 in) 3. After adding fuel, push float gauge (G) straight down with fuel filler cap (F). Be careful not to get float gauge (G) caught in the tab of fuel filler cap (2), and tighten fuel filler cap (F) securely. Remark If breather hole (3) in the cap is clogged, the pressure inside the tank will go down and no fuel will be supplied, so clean the breather hole periodically. The diagram on the right shows the rear surface of the cap. 2-122 PC200LC-8