OPERATION Hydraulic System Warm-Up Before carrying out the warm-up operation for the hydraulic equipment, turn the swing lock switch ON, check on the monitor that the swing lock monitor lights up to show that the swing lock is actuated, then start the warm-up operation. When warming up the hydraulic system, check that there is no person or obstacle in the surrounding area, then sound the horn and start the operation. Carry out the warm-up operation for the hydraulic system until the hydraulic oil temperature monitor indicates that the hydraulic oil has reached the operating temperature range. Hydraulic oil temperature indicator (A) Display when temperature is within operating range:
Monitor background (C) is blue (B) Display when temperature is low: Monitor background (C) is white The warm-up operation for the hydraulic system is necessary not only for the circuit between the pump and cylinders and between the pump and motor, but also for all the control circuits. Do not carry out the operation just for one cylinder or motor, or the operation just in one direction. Carry out the operation in both directions for the work equipment (boom, arm, bucket), swing, travel, and attachment (if equipped). 1. Check that engine coolant temperature monitor (1) displays the operating temperature range. (A) Display when temperature is in operating range:
Monitor background (C) is blue (B) Display when temperature is low: Monitor background (C) is white If it displays low temperature, carry out additional warm-up of the engine until engine coolant temperature monitor (1) displays a blue background. For details of the procedure, See “Engine Warm Up” on page 2-139. 2-142 PC200LC-8