OPERATION MACHINE OPERATION Before operating the control levers and control pedals, check the direction that the track frame is facing. When the track frame is facing the rear (when the sprocket is at the front), the direction of operation of the travel levers and control pedals is the opposite from the direction of movement of the machine (forward/reverse, steering to left/right). When moving the machine, check that the area around the machine is safe, and always sound the horn before moving. Do not allow anyone in the area around the machine. Remove all obstacles from the travel path of the machine. The rear of the machine is a blind spot, be extremely careful when traveling in reverse.
If the lever is moved inside the deceleration range, engine speed will rise suddenly. Operate the levers carefully. For machines equipped with a travel alarm, check that the warning equipment works properly. Preparations for Moving the Machine 1. Set swing lock switch (1) to the ON (actuated) position and confirm that swing lock monitor lamp (2) lights up. (a): ON position (b): OFF position 2. Turn fuel control dial (3) towards the full speed position to increase the engine speed. PC200LC-8 2-151