OPERATION WORKING MODE Working Mode Switch Use working mode selector switch (1) to select the working mode that matches the operating conditions or purpose. This will make it possible to carry out operations efficiently. Use the following procedure to select the most efficient working mode. When the starting switch is turned ON, the working mode is set to the mode that was in operation when the starting switch was last turned OFF. Use the working mode switch to set the mode to the most efficient mode to match the type of work. Remark If breaker operations are carried out in a mode other than the breaker mode, there is danger of breakage of the hydraulic equipment.
Do not carry out breaker operations in any mode except the breaker mode. 1. If working mode selector switch (1) is pressed, the working mode selection screen is displayed on the monitor. 2-160 PC200LC-8 Working mode Applicable operations P mode Normal digging or loading operations (operations with emphasis on production) E mode Normal digging or loading operations (operations with emphasis on fuel consumption) L mode Aligning position (fine control operations) B mode Breaker operations ATT mode Operations with the crusher or other double-acting action attachment