OPERATION TRAVELING ON SLOPES Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such operations. It is particularly dangerous to swing downhill when the bucket is loaded. If such operations have to be performed, pile soil to make a platform (A) on the slope so the machine is kept horizontal during operation. Do not travel up or down steep slopes. There is a danger that the machine may turn over. When traveling, raise the bucket approximately 20 to 30 cm (8 to 12 in) from the ground. Do not travel downhill in reverse. Never turn on slopes or travel across slopes.
Always go down to a flat place to perform these operations. It may be longer, but it will ensure safety. Always operate or travel in such a way that it is possible to stop safely at any time if the machine slips or becomes unstable. When traveling uphill, if the shoes slip or it is impossible to travel uphill using only the force of the tracks, do not use the pulling force of the arm to help the machine travel uphill. There is danger that the machine may turn over. 1. When traveling down steep hills, use the travel lever and fuel control dial to keep the travel speed low.
When traveling down a steep hill of more than 15°, set the work equipment to the posture shown in the diagram on the right, and lower the engine speed. 2-166 PC200LC-8