MAINTENANCE TORQUE SPECIFICATIONS Torque List If nuts, bolts, or other parts are not tightened to the specified torque, it will cause looseness or damage to the tightened parts, and this will cause failure of the machine or problems with operation. Always pay careful attention when tightening parts. Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the table below. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced.
Torque of Bolts 3-12 PC200LC-8 Thread diameter of bolt Width across flats mm mm N•m lbf ft 6 10 11.8 - 14.7 8.70 - 10.84 8 13 27 - 34 19.91 - 25.07 10 17 59 - 74 43.51 - 54.57 12 19 98 - 123 72.28 - 90.72 14 22 153 - 190 112.84 - 140.13 16 24 235 - 285 173.32 - 210.20 18 27 320 - 400 236.02 - 295.02 20 30 455 - 565 335.59 - 416.72 22 32 610 - 765 449.91 - 564.23 24 36 785 - 980 578.98 - 722.81 27 41 1150 - 1440 848.19 - 1062.09 30 46 1520 - 1910 1121.09 - 1408.74 33 50 1960 - 2450 1445.62 - 1807.02 36 55 2450 - 3040 1807.02 - 2242.19 39 60 2890 - 3630 2131.55 - 2677.35