Komatsu — Check, Clean and Replace Air Cleaner Element

MAINTENANCE Remark Be sure to install the air cleaner element facing in the correct direction. Install so that the bottom of the air cleaner element cylinder (face where no hole is drilled) (B), (C) is at cover (3) end. If the direction of installation is mistaken, there is danger that it will cause breakage of the air cleaner element or serious damage to the engine. 8. Replace O-ring (8) of cover (3) with a new part. Remark When inserting the element, if the rubber at the tip is swollen or the outer element is not pushed in straight, and cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be damaged, so be careful when assembling. 9.

Install cover (3) as follows: A. Align cover (3) with the element. B. Hook the tip of hook (2) to the protruding part of the air cleaner body and lock it in position. C. When locking hooks (2) in position, apply the hooks in turn on opposite sides (top, bottom, left, right) in the same way as when tightening bolts. D. Always install cover (3) so that the evacuator (4) is facing the ground (A). E. When cover (3) is installed, check that the clearance between the air cleaner body and cover (3) is not too large. If it is too large, install again. PC200LC-8 3-27