Komatsu — Clean Inside of Cooling System

MAINTENANCE Clean Inside of Cooling System • Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to drain the coolant in this condition, there is a hazard of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure before removing it. • Cleaning is carried out with the engine running. When standing up or leaving the operator's seat, set the lock lever (1) to the LOCK position (L). • For details of starting the engine, See “Before Starting Engine” on page 2-115 and “STARTING ENGINE” on page 2-134.

• There is danger of touching the fan if the undercover is left removed. • Never enter behind the machine when the engine is running. Clean the inside of the cooling system, change the coolant and replace the corrosion resistor according to the table below. *: Permanent type antifreeze shall meet the requirements of ASTM D3306-03. Stop the machine on level ground when cleaning or changing the coolant. The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC).

Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for two years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. PC200LC-8 3-29 Antifreeze coolant Interval of cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first