Komatsu — Lubricating

MAINTENANCE Every 100 Hours Maintenance Lubricating Remark If any abnormal noise is generated from any greasing point, carry out greasing regardless of the greasing interval. Carry out greasing every ten hours for the first 50 hours on a new machine. After the machine has been subjected to jobs in the water, be sure to grease the wet pins. 1. Set the work equipment in the greasing posture below, then lower the work equipment to the ground and stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out.

(1) Arm - Bucket coupling pin (one place) (2) Arm - Link coupling pin (one place) 3-52 PC200LC-8