MAINTENANCE Clean and Inspect Radiator Fins, Oil Cooler Fins, Aftercooler Fins, Fuel Cooler Fins, and Condenser Fins (Only Machines Equipped With Air Conditioner) If compressed air, high-pressure water, or steam hits your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. Remark When using compressed air for cleaning, keep some distance to avoid damaging the fins. Damage on the fins can cause water leakage and overheating. In a dusty job site, check the fins every day, regardless of the main- tenance interval. 1. Open engine hood (1). 2. Loosen screw (3) and pull up net (2). 3.
After pulling up net (2), clean it. (Install it again in Step 7.) 4. Check the front and rear surfaces of oil cooler fins (4), radiator fins (5), aftercooler fins (6), condenser fins (7), and fuel cooler fins (8). If there is any mud, dirt, or leaves stuck to the fins, blow the dirt off with compressed air. Steam or water may be used instead of compressed air. However, when carrying out powerful steam cleaning (high-pressure machine wash) of the heat exchange equipment (radiator, oil cooler, aftercooler, fuel cooler, condenser), maintain sufficient distance from the machine when carrying out the operation.
If steam cleaning (high-pressure machine wash) is carried out at close range, there is danger that the internal fins of the heat exchange equipment may be deformed, and this will cause early clogging and breakage. Remark Do not wash cameras. They cannot withstand high pressure spray or steam. Wipe cameras off with soft cloths. 5. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by aging. In addition, check the hose clamps for looseness. PC200LC-8 3-65