MAINTENANCE Clean Air Conditioner Fresh/Recirc Filters If compressed air is used, there is danger that dirt may fly and cause personal injury. Always wear protective glasses, dust mask, and other protective equipment. Remark As a guideline, the filters should be cleaned every 500 hours, but on dusty jobsites, clean the filters more frequently. Remark If the filter becomes clogged, the air flow will be reduced, and there will be an abnormal noise from the air conditioner unit. Cleaning Recirculated Air Filter 1. Remove wing bolts (1) from the inspection window at the bottom rear left on the inside of the operator's cab, then take out the recirculated air filter. 2.
Clean the filter with compressed air. If there is oil on the filter, or if the filter is extremely dirty, wash it in a neutral agent. After rinsing it in water, dry it thoroughly before using it again. Replace the filter with a new part every year. If the clogging of the filter cannot be removed by blowing with air or washing in water, replace the filter immediately. The RECIRC filter must be installed facing in the correct direction. Install it so that the projecting part faces the front of the machine. Cleaning Fresh Air Filter 1. Use the starting switch key to open cover (2) at the rear left of the operator's cab, then open cover (2) by hand and remove filter (3) inside the cover. 2.
Clean the filter with compressed air. If there is oil on the filter, or if the filter is extremely dirty, wash it in a neutral agent. After rinsing it in water, dry it thoroughly before using it again. Replace the filter with a new part every year. If the clogging of the filter cannot be removed by blowing with air or washing in water, replace the filter immediately. 3. After cleaning, return filter (3) to its original position and close the cover. Use the starting switch key to lock the cover. Do not forget to remove the starting switch key. Remark The FRESH filter must be installed facing in the correct direction.
When installing, insert the long (L) end of filter (3) into the filter case first. If the short (S) end is installed first, cover (2) will not close. 3-68 PC200LC-8