MAINTENANCE Check Oil Level in Swing Machinery Case, Add Oil • Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 1. Remove dipstick (G) and wipe the oil from the dipstick with a cloth. 2. Fully insert dipstick (G) into the filler pipe. 3. Pull out dipstick (G) and check that the oil level is between the H and L marks on the dipstick. 4. If the oil does not reach the L mark on dipstick (G), remove the cap of oil filler port (F) and add oil. Remove dipstick (G) when adding oil. 5.
If the oil is above the H mark on the dipstick, loosen drain valve (P) and drain the excess oil. For details of the method of draining the oil, See “Change Oil in Swing Machinery Case” on page 3-73. 6. After checking oil level or adding oil, insert the dipstick (G) into the hole and install oil filler (F) cap. 3-70 PC200LC-8