Komatsu — Change Oil in Hydraulic Tank

MAINTENANCE Every 5000 Hours Maintenance Maintenance for every 100, 250, 500 and 1000 hours service should be carried out at the same time. Change Oil in Hydraulic Tank • The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. • When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. Remark If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, See “Maintenance Interval for Hydraulic Breaker” on page 3-20 when carrying out maintenance.

Refill capacity: 135 liters (35.67 US gal) Prepare a handle (for the socket wrench). 1. Swing so that the drain plug at the bottom of the hydraulic tank is in the middle between the left and right tracks. 2. Retract the arm and bucket cylinders, then lower the boom and put the teeth in contact with the ground. 3. Set the lock lever to the LOCK position and stop the engine. 4. Remove the cap of oil filler port (F) at the top of the hydraulic tank. 5. Set a container directly under the drain plug under the machine to catch the oil that is drained. Remove drain plug (P) and drain the oil. Check that the O-ring installed to plug (P) is not damaged. If it is damaged, replace the O-ring.

After draining the oil, tighten drain plug (P). Drain plug torque: . . . . . . . . . . . .68.6 ±9.81 N·m (50.6 ±7.2 lb/ft) Take care not to get oil on yourself when you remove drain plug (P). 6. Fill with the specified amount of oil through oil filler port (F). Check that the oil level is between the H - L lines on the sight gauge. For details of the suitable oil, See “RECOMMENDED FUEL, COOLANT, AND LUBRICANT” on page 3-9. For details of the method of checking the oil level, See “Check Oil Level in Hydraulic Tank, Add Oil” on page 2-118. 3-88 PC200LC-8