OPTIONS, ATTACHMENTS PC200LC-8 This table lists the combination of attachments which can be installed to the long arm (standard), short arm and extension arm. : Can be used : Can be used only for light duty work : Cannot be used Remark • When the extension arm is equipped, if the bucket is drawn to the machine body, the arm interferes with the body. Operate the extension arm carefully. • When the boom is fully lowered during oblique digging, the boom interferes with the undercarriage. Operate the boom carefully. Categories of use For general digging: Digging or loading sand, gravel, clay etc. For light duty digging: Digging or loading dry, un-caked earth and sand, mud etc. For loading work:
Loading dry, loose earth and sand For digging or loading hard soil or soft rock, it is recommended that the strengthened bucket with high durability and high wear resistance be employed.
*:Equipped with side cutter PC200LC-8 5-27 Name of bucket Capacity m3 (cu.yd) Outside width mm (ft in) Use Standard arm 2.9 m (9 ft 6 in) Short arm 2.4 m (7 ft 10 in) Short arm 1.8 m (5 ft 11 in) Extension arm 1.1 m (3 ft 7 in) *Narrow bucket 0.50 (0.65) 750 (2' 6") Narrow digging ❍ ❍ ❍ ❍ *Narrow bucket 0.60 (0.78) 970 (3' 2") Narrow digging ❍ ❍ ❍ ✪ *Standard bucket 0.8 (1.05) 1,150 (3' 9") General digging ❍ ❍ ❍ ✪ *Light duty bucket 0.9 (1.18) 1,200 (3' 11") Light duty digging ▲ ❍ ❍ ✪ Light duty bucket 1.0 (1.3) 1,330 (4' 4") Loading ▲ ▲ ▲ ✪ Light duty bucket 1.17 (1.5) 1,450 (4' 9") Loading ✪ ▲ ▲ ✪ Slope finishing bucket 0.40 (0.52) - Slope finishing ❍ ❍ ❍ ✪ Trapezoidal bucket (Variable slope type) 0.55 (0.72) - Trapezoidal shaped diching ❍ ❍ ❍ ✪ Ripper bucket 0.61 (0.80) 950 (3' 1") Digging rocks ✪ ❍ ❍ ✪ Clamshell bucket 0.66 (0.86) 866 (2' 10") Ditching, loading ❍ ❍ ❍ ✪ Ditch cleaning bucket 0.8 (1.05) 1,800 (5' 11") Ditching, cleaning ❍ ❍ ❍ ✪ One tooth ripper - - Digging, remov- ing rocks ❍ ❍ ❍ ✪ Three teeth ripper - - Digging, remov- ing rocks ❍ ❍ ❍ ✪