Komatsu — Basic Precautions

OPTIONS, ATTACHMENTS HANDLING MACHINES EQUIPPED WITH KOMTRAX KOMTRAX is a machine management system that uses wireless communications. A contract with your Komatsu distributor is necessary before the KOMTRAX system can be used. Any customers desiring to use the KOMTRAX system should consult their Komatsu distributor. The KOMTRAX equipment is a wireless device using radio waves, so it is necessary to obtain authorization and conform to the laws of the country or territory where the machine equipped with KOMTRAX is being used. Always contact your Komatsu distributor before selling or exporting any machine equipped with KOMTRAX.

When selling or exporting the machine or at other times when your Komatsu distributor considers it necessary, it may be necessary for your Komatsu distributor to remove the KOMTRAX equipment or to carry out action to stop communications. If you do not obey the above precautions, neither Komatsu nor your Komatsu distributor can take any responsibility for any problem that is caused or for any loss that results. Basic Precautions Never disassemble, repair, modify, or move the communications terminal, antenna, or cables. This may cause failure or fire on the KOMTRAX equipment or the machine itself.

(Your Komatsu distributor will carry out removal and installation of KOMTRAX.) Do not allow cables or cords to become caught; do not damage or pull cables or cords by force. Short circuits or disconnected wires may cause failure or fire on the KOMTRAX equipment or the machine itself. For anyone wearing a pacemaker, make sure that the communication’s antenna is at least 22 cm (8.7 in) from the pacemaker. The radio waves may have an adverse effect on the operation of the pacemaker. Remark • Even when the key in the starting switch of the KOMTRAX system is at the OFF position, a small amount of electric power is consumed.

When putting the machine into long-term storage, take the action given in “LONG TERM STORAGE” on page 2-194. • Please contact your Komatsu distributor before installing a top guard or other attachment that covers the cab roof. • Be careful not to get water on the communications terminal or wiring. Remark • The KOMTRAX system uses wireless communications, so it cannot be used inside tunnels, underground, inside buildings, or in mountain areas where radio waves cannot be received. Even when the machine is outside, it cannot be used in areas where the radio signal is weak or in areas outside the wireless communication service area.

• There is absolutely no need to inspect or operate the KOMTRAX communications terminal, but if any abnormality is found, please consult your Komatsu distributor. Remark • The new updated monitor (7 in. monitor) requires the key switch to be on for a minimum of two consecutive hours before KOMTRAX comes out of Power Save mode. In addition, the updated monitor if put into long term storage (longer than 14 days) will prevent battery discharge. Remark • KOMTRAX reporting on error codes may indicate a DY2CKA error code. the standard description is “Wind Wash Motor + Open Circuit”.

This code may also be associated with frequent replacement of the 10 Amp Fuse located in Fuse socket #4 of the fuse panel. • In troubleshooting, the technician is advised to check the condition of the heating coil element in the cigarette lighter. If the heating coil element is heavily worn or damaged, short circuit can occur and the #4 fuse will blow. When this happens, the monitor panel registers error code DY2CKA. PC200LC-8 5-39