* Canceling automatic warming-up operation If it becomes necessary in an emergency to lower the engine speed to low idling, cancel the automatic warming-up operation as follows. 1. Set the power mode to S mode or H mode. 2. Turn the fuet control dial to the full speed (MAX) position and hold it for 3 seconds. 3. When the fuel control dial is returned to the low idling (MIN) position, the engine speed will drop. CAUTIONS AFTER COMPLETION OF WORK 1. Mud and water on the machine body should be completely removed. Park the machine on concrete or hard ground. If this is impossible, park the machine on wooden boards.
This will prevent the accessories from freezing or the track and undercarriage from freezing to the ground thereby preventing vehicle movement the next morning. Particular atten- tion should be given to water drops collected on the surface of the hydraulic cylinder piston rods. Such droplets must be fully wiped off because if water is frozen to the rod when the cylinder is utilized, the cylinder oil seals may be damaged. 2. Drain water collected in fuel system so that such water may be frozen at night. 3. As battery capacity drops at low ambient temperature, cover the battery or remove it from the machine to be kept warm at night.
AFTER COLD WEATHER When weather becomes warm, perform the following without fail: l Replace lubricating oils for various units with the ones specified for warm-weather use. l If for any reason permanent antifreeze connot be used, and an ethyl gly- col base antifreeze (winter, one season type) is used instead, or if no antifreeze is used, drain the cooling system completely, then clean out the inside of the cooling system thoroughly, and fill with fresh water. PREPARING THE CAB HEATER If the ambient temperature drops, use the cab heater. 1. When using the cab heater, turn valve (1) on the water manifold coun- terclockwise to open it. 2.
When leaving the cab heater unused for a long time, turn valve (I) clock- wise to close it. - 98 -