Komatsu — BLEEDING AIR FROM CIRCUIT

BLEEDING AIR FROM CIRCUIT After replacing or cleaning the hydraulic oil, filter element, or strainer, or after repairing or replacing the hydraulic equipment, or after removing the hydraulic piping, bleed the air from the circuit. PROCEDURE FOR BLEEDING AIR Air bleeding item Air bleedina orocedure Bleed air start Bleed air Bleed air Bleed air from engine from pump cylinder from swing from travel op$$fons motor motor 1 2 3 4 5 6 Nature of work Change hydraulic oil Clean strainer 0 ~o+o-o-o-o . Replace return filter element 0 W 0 Replace, repair pump . Remove suction piping 0 -0-o -0-o-o Replace, repair control valve 0-0-0-0-0 . Replace cylinder Remove cylinder piping o-o * 0 .

Replace swing motor Remove swing motor piping 0 * 0 --0 Replace travel motor, swivel Remove travel motor, swivel piping 0 *o-o a. 1. Bleeding air from pump Loosen air bleed plug (I), and check that oil oozes out from the air bleed plug. If oil does not ooze out from the plug, remove the drain hose from the pump case, and add oil through drain port (2) to fill the pump case with hydraulic oil. Oil will come out from the drain hose when it is removed, so secure the mouth of the hose at a place higher than the oil level inside the hydraulic tank. After completion of the air bleed operation, tighten air bleed plug (I), then install the drain hose.

If the drain hose is installed first, oil will spurt out from the hole of plug 2. (1). If the pump is operated without filling the pump case with hydraulic oil, abnormal heat will be generated and this may lead to premature damage of the pump. -102-