EVERY 250 HOURS SERVICE FINAL DRIVE CASE Set the UP mark at the top, with the UP mark and plug (P) perpendicular to the ground surface. Remove plug (F), and check that oil level is within 10 mm below the bot- tom of the plug hole. If it is not within this range, add engine oil through the plug hole. If the inspection shows that the oil level is low, turn the sprocket one turn, then check the oil level again. The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. b. ENGINE OIL PAN AND FILTER 1. Remove drain plug (P) under the chassis, drain the oil, then tighten it again. 2.
Using a filter wrench, remove cartridge (1) of the engine oil filter by turn- ing it counterclockwise. 3. Clean the filter holder, coat the seal surface of the new filter cartridge with engine oil (or coat it thinly with grease), then install. t When installing, to prevent overtightening, tighten until the packing sur- face contacts the seal surface of the filter holder, then tighten a further l/2 turn by hand. 4. After replacing the cartridge, pour in the specified quantity of engine oil from oil filler (F). 5. Run the engine at idling for a short time, then stop the engine and check that the oil level is correct. For details, see CHECK BEFORE STARTING. * Refill capacity:
17.5 P * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. * Be sure to fit a genuine Komatsu cartridge. * Replace once every 6 months, regardless of the number of hours oper- ated. * When supplying oil, be careful not to get oil on the alternator. * If filter cartridge (1) is removed immediately after stopping the engine, oil will spill. Wait at least 10 minutes after stopping the engine before replac- ing the filter cartridge. * Use API category CD class oil. If CC class oil must be used, change the oil and replace the oil filter at half the usual interval (125 hours). - 122-