Komatsu — EVERY 1000 HOURS SERVICE

EVERY 1000 HOURS SERVICE * Maintenance for every 100, 250 and 500 hours should be carried out at the same time. SWING MACHINERY CASE Drain off oil from drain valve (P) at the bottom of the machine. After draining, tighten the drain valve (P). Pour in the specified amount of engine oil from gauge hole (G). (Refer to EVERY 100 HOURS SERVICE.) For the method of checking the oil level, see the maintemance for EVERY 100 HOURS SERVICE. The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. Refill capacity: 9.3 Q * * b. DAMPER CASE Remove plug (G) and check that the oil is near the bottom edge of the plug hole.

If the oil level is low, add engine oil through oil filler (F). C. TURBOCHARGER CLAMPING JOINT Contact your Komatsu distributor for checking, or proceed as follows: Periodically inspect all joints for looseness. Tighten when necessary. Tightening torque for bolts on turbine housing side: 1.84 - 2.19 kgm Tightening torque for clamp bolts on blower housing side: 1 .I 5 - 1.50 kgm 0 0 0 Tightening torque for exhaust manifold and turbine housing mounting bolts: 6.0 - 7.5 kgm 0 0 Tightening torque for turbocharger oil pipe (inlet): 2.8 - 3.5 kgm Tightening torque for turbocharger oil pipe (outlet): 6.0 - 7.5 kgm d.

TURBOCHARGER ROTOR PLAY Contact your Komatsu distributor for checking, or proceed as follows: Remove air intake and exhaust pipes from turbocharger. Axial play Check axial play by moving rotor in axial direction. Play: Standard Radial play 0.025 to 0.100 mm Measure radial play by moving rotor holding both ends by hands in radial direction in parallel. Play: Standard 0.075 to 0.180 mm If the play is over the limit, consult your Komatsu distributor. ._ * It the rotor is excessively soiled with dust or carbon or if any oil leakage caused by turbocharger trouble is noted, have the turbocharger repaired by your Komatsu distributor. - 132-