e. CORROSION RESISTOR 1. Screw in valves (1) at the top of the corrosion resistor. 2. Using a filter wrench, turn cartridge (2) counterclockwise and remove it. 3. Coat the seal surface of the new cartridge with engine oil. t To prevent overtightening, bring the packing surface into contact with the seal surface of the filter holder, then tighten by hand a further 2/3 turns. 4. Open valves (1). * Use a genuine Komatsu cartridge. 5. Start the engine and check that there is no leakage of water from the seal surface. - 134-