Komatsu — EVERY 2000 HOURS SERVICE

b. HYDRAULIC TANK STRAINER 1. Remove the cap of oil filler (F). 2. Remove cover (1) and lift up the top of rod (3) from above to take out spring (2) and strainer (4). 3. Wash the strainer with fuel oil. If strainer (4) is damaged, replace it with a new one. 4. Refit strainer (4) by inserting it into tank projecting part (5). A When removing the cap, turn it slowly to relieve inner pressure. A When removing cover (I), undo the bolts (4 bolts) gradually to prevent the cover flying off under the force of spring (2). c. FINAL DRIVE CASE 1. Set the UP mark at the top, with the UP mark and plug (P) perpendicular to the ground surface. 2.

Drain the oil from drain plugs (P) on both sides of the machine. After draining, tighten the drain plugs. 3. Then, supply new engine oil through oil filler (F) respectively to the speci- fied level. (Refer to EVERY 250 HOURS SERVICE.) * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. * Refill capacity: 7.6 Q - 138-