* If a corrosion resistor cartridge is installed, close valves (1). 1. Stop the engine. 2. Turn water filler cap (2) slowly until it comes off. A If the water temperature is high, do not remove the cap. This is because of the possibility of scalding water spurting out. When removing the cap, turn the cap slowly to allow pressure to be relieved. 3. Open drain valve (3) at the bottom of the radiator and plug (4) on the side of cylinder block to drain off the cooling water. 4. After draining the cooling water, close up drain valve (3), plug (4), and pour in soft water (ex; city water) up to the vicinity of the water filler. 5.
When the water reaches the vivinity of the water filler, put the engine at low idling, open drain valve (3), plug (4), then pass water for 10 minutes valve (3), plug (4). through the cooling system until clean water comes out from drain t When doing this, adjust the speed of filling and draining the water so 6. When the water becomes completely clean, stop the engine, draining off that the radiator is always full. 7. After draining the water, clean with a cleaning agent. the cooling water, and close drain valve (3), plug (4). * We recommend use of a Komatsu genuine cleaning agent. For details of the cleaning method, see the instructions given with the cleanig agent. 8.
After cleaning, drain all the cooling water, then close the drain valve (3), plug (4) and fill slowly with clean water. 9. When the cooling water comes up to near the radiator water filler port, start the engine, and run at low idling. Add clean water, open drain valve (3), plug (4) and continue to run water until clean colorless water * When doing this, adjust the speed of filling and draining the water SO comes out from the drain valve (3) and plug (4). IO. When the water is completely clean, stop the engine and close drain that the radiator is always full. * If a corrosion resistor cartridge is installed, replace the cartridge and valve (3), plug (4). open valves(l).
(For details, see EVERY 1000 HOURS SERVICE.) * In areas where the water is hard, if there is no corrosion resistor car- tridge installed, always add genuine Komatsu anticorrosion agent KI. (For details of the adding procedure, follow the instructions on the agent.) 11. Add cooling water until it overflows from the water filler. - 144-