c. CHECK TRACK TENSION The wear of pins and bushings on the undercarriage will vary with the working conditions and soil properties. It is thus necessary to continually inspect the track tension so as to maintain the standard tension on it. If the track tension is not at the standard value, adjust it in the follow- ing manner: Inspection 1. Raise the chassis with the boom and arm. 2. The standard clearance between the bottom of the track frame and the top surface of the track shoe is 303 + 20 mm. (a): Track frame (b): Track shoe * Places to measure PC200: 4th track roller from sprocket PCPOOLC: 5th track roller from sprocket PC220: Between 4th and 5th track roller from sprocket PC22OLC:
Between 5th and 6th track roller from sprocket Adjustment If the tension is not the standard value, adjust as follows. 1. To increase the tension, remove the cover and pump in grease through grease fitting (1). To release the tension, loosen plug (2) a little at a time to release the grease. 2. It is permissible to insert grease until S becomes 0 mm. If, despite doing this, the track tension is still low, the pin and bushing have become excessively worn and must either be inverted or replaced. Have this work done by Komatsu distributor. A When loosening plug (2). do not slacken it by more than one turn. Also, during this operation, do not loosen any part other than plug (2).
(This is because of the danger of grease spurting out under high pressure.) If the grease comes out sluggishly, move the machine slightly backward and forward. - 150-