* The life of the point can be lengthened and the frequency of its replace- ment can be reduced by turning it upside down so that it will wear * When replacing the point, replace the rubber pin and lock pin with new evenly. ones. This will prevent the point from falling. g. CLEAN LINE FILTER If the hydraulic piping between the pump and line filter has been removed, or if there is any abnormality in the hydraulic equipment, remove the dirt inside the circuit as follows. 1. Remove drain plug (1). 2. Remove case (2), and clean filter (3). * When cleaning the filter, remove all dirt stuck to the side of the filter.
* When reassembling the filter case, replace O-ring (4) and backup ring (5) at the same time. * After reassembling the line filter, start the engine and run at low idling for 5 minutes to bleed the air. It is not necessary to operate the control levers to bleed the air. h. DRAIN WATER FROM WATER SEPARATOR When float (2) is at or above red line (I), drain the water according to the following procedure: 1. Loosen drain plug (3) and drain the accumulated water until the float reaches the bottom. 3. If the air is sucked into the fuel line when draining the water, be sure to 2. Tighten drain plug (3). bleed the air in the same manner as for the fuel filter.
(See Fuel Filter Cartridge in EVERY 500 HOURS SERVICE section.) (a): To fuel filter (b): From fuel tank -156-