Komatsu — SAFETY HINTS

12. Always concentrate. It is extremely dangerous to allow yourself to be distracted or to think of other things when operating a machine. In dangerous places, or where there is restricted visibility, it is important to get down from the machine and confirm whether it is safe before con- tinuing work. 13. Be careful of those around you, and always confirm that there is no person or obstacle in the way before moving or turning the machine. 14. When using the work equipment, be sure to keep your eyes on it all the time. Failure to do this may result in an accident. 15. When passing through a narrow space, be careful of the side and over- head clearances.

Take special care not to touch any obstacles on either side or overhead. If necessary, have someone outside the machine call out instructions. 16. Be careful not to operate the machine into a bog. In the event that the machine goes into a bog, extract it in the following manner; 1) If only one track of the machine is in the bog, push the bucket down against the ground on the side of the machine which is stuck so as to float the track. Then place logs or timber underneath the track and free the machine.

* When raising the undercarriage by means of the boom or arm, push the bottom of the bucket against the ground (on no account use the teeth) until the angle between the boom and the arm is 90” to 110”. 2) If both tracks of the machine are in the bog and slip, preventing the machine from getting in, place logs or timber under the tracks in the manner described in I), then thrust the bucket into the soil in front of the machine and drag it out by bending the arm in the same manner as when excavating and putting the traveling and steering lever into the forward position. 17.

After earthquakes, confirm that the ground is still firm; after blasting, confirm that there are no unexploded charges remaining. 18. When working on river embankments or other places made of piled soil, there is the danger that the weight of vibration of the machine may cause the machine to sink into the piled soil, so be extremely careful when operating in such places. 19. When continuing operations after rain, remember that conditions will have changed from those before the rain started, so proceed with cau- tion. Be particularly careful when approaching the shoulder of the road of cliffs, as they may have been loosened by the rain. 20. Check the load limits of bridges before crossing.

21. When working in water or marshy ground, be careful of the following: * When working on soft ground, place thick boards on the ground to prevent the machine sinking. Place the boards horizontally and arrange them as neatly as possible. -lO-