Komatsu — LOCKING CAP

LOCKING CAP Locks are installed to the fuel tank filler cap, hydraulic tank filler cap, operator’s cab, left side door (rear), and engine hood. * Use the starting key to open and close the cap. Open and close locking cap as follows: (For the fuel tank filler port) A: To open the cap 1. Insert the key into the cap. (a): OPEN (b): LOCK 2. Turn the key clockwise, align the match mark on the cap with the rotor groove, then remove the cap. 1. Turn the cap into place. 2. Turn the key counterclockwise and take the key out. B: To lock the cap (For the hydraulic tank filler port) C: To open the cap 1. Insert the key into the cap. (a): LOCK (b): OPEN 2.

Turn the key counterclockwise and bring the rotor groove in line with the aligning mark on the cap. Turn the cap slowly until a “clicking” sound is made. This releases the lock and allows the cap to be opened. (a): Aligning mark D: To lock the cap 1. Turn the cap into place. 2. Turn the key clockwise and take the key out. * When the cap is locked (against vandalism), it rotates freely. * Insert the key as far as it will go. If the key is turned before it is inserted all the way, it may break. (a): Shoulder - 22 -