CHECKING AND MAINTAINING CAR COOLER a. Checking coolant level If the cooling effect is poor, check the side glass (liquid eye) of the receiver drier. If there are many bubbles, the coolant level is too low. Check whether there is any coolant, and have the cooler serviced. b. Clogging of condenser If there is any dirt or mud stuck to the condenser, there will be a big reduction in the cooling efficiency of the condenser. That will mean a reduc- tion in the cooling capacity, so clean the dirt and mud off and correct any bent fins with a screw-driver. c.
Checking and adjusting V-belt tension The slack should be 8 to 13 mm when pushed with a finger force of about 6 kg midway between the compressor pulley (1) and the crankshaft pulley (2). (3): Tension pully (4): Alternator pully To adjust, loosen three bolts (5), then loosen lock nut (6) and move the compressor with adjustment bolt (7). - 26 -