DRESSTA Co. Ltd. TD-15H — 5.11.3. ADJUSTMENT OF ENGINE VALVES

SECTION 5 MAINTENANCE Page 30 ENGINE 4. Position the first cylinder piston in the top dead center (TDC) by turning the pinion on the rack (No 3824591) by hand and simultaneously pressing a timing pin (Fig. 5.17). When the pin slides into the camshaft hole, the cylinder piston has reached the top dead center (TDC). Fig. 5.17. Positioning a Cylinder Piston in TDC IMPORTANT: When the piston is positioned in its TDC remove the pin so as not to cause damage to the pin or engine. 5. Check and adjust (step 1), if necessary, the valve lash as shown in Fig. 5.18. Use a screw driver, a wrench and a filler gauge. The value of the valve lash should be as follows: Intake valve (I):

0.30 [mm], Exhaust valve (E): 0.61 [mm]. Tighten the adjusting nut up to the torque of 24 [Nm] and check the lash again. Fig. 5.18. Engine Valves (Step 1) I. Intake Valves E. Exhaust Valves TD-15H DRESSTA