DRESSTA Co. Ltd. TD-15H — 5.12. FUEL SYSTEM

MAINTENANCE SECTION 5 Page 33 ENGINE INSPECTION AND CLEANING Make certain that ether is available under pressure. To do so, remove the ether container and check if a good spray is obtained. Test the ether injector as follows: 1. Disconnect the ether tube at the spray nozzle in the engine manifold. Remove the spray nozzle. 2. Reconnect the nozzle to the tube. Direct the nozzle away from the engine and actuate the ether injector. Dribbling or no spray indicates a blocked spray nozzle or tube. If necessary, clean or replace spray nozzle and/or tube. CHANGING THE FLUID CONTAINER 1. Loosen the clamp screw securing the fluid container in the support saddle. 2.

Unscrew and discard the container from the ether starting valve in a suitable, closed refuse container. 3. Install a new container in the valve. 4. Secure the container in place by tightening the clamp screws. Fig. 5.22. Ether Fluid Container 1. Ether Container 2. Clamp 3. Support Saddle 4. Seal Ring 5. Electric Wire 6. Injector 7. Injection Pipe 8. Plug for Container Socket 5.12. FUEL SYSTEM GENERAL Cleanness of diesel fuel determines the service life of the fuel system components. Water and contaminants, allowed to reach precision components, cause rapid wear and poor performance.

Clean fuel and regular servicing of the fuel tank and fuel filtering components are necessary for long service life. Always clean the area around the fuel tank filler cap before refueling. DRESSTA TD-15H