DRESSTA Co. Ltd. TD-15H — 5.13.2. CHANGING HYDRAULIC OIL

MAINTENANCE SECTION 5 Page 37 5.13. HYDRAULIC SYSTEM General WARNING! Always lower all mounted equipment to the ground before performing work on the hydraulic system. With all mounted equipment lowered to the ground and the engine off, cycle all hydraulic controls in all directions to relieve trapped pressure. Slowly loosen the hydraulic reservoir filler cap to relieve trapped reservoir pressure. 5.13.1. CHECKING OIL LEVEL 1. Park the machine on level ground, lower the blade and the ripper to the ground and stop the engine. 2. Check the oil level at the sight gauge on the side of the reservoir. Add oil if the level is below the centerline of the gauge. Refer to "CHANGING HYDRAULIC OIL". Fig.

5.28. Hydraulic Reservoir Sight Gauge IMPORTANT: Before removing any components from the reservoir or servicing, wipe the top surface of the reservoir, using clean kerosene or a commercial cleaning solvent. 5.13.2. CHANGING HYDRAULIC OIL 1. Start the engine and operate the blade to warm the oil for easy draining. 2. Park the machine on level ground lower the blade and the ripper to the ground. 3. Stop the engine. Shift the transmission lever to neutral and apply the neutral lock lever. Apply and lock the parking brake. Turn the electric system master switch to OFF and remove the key. Slowly loosen reservoir filler plug to relieve reservoir pressure. 4.

Drain the reservoir into a suitable container by removing the filler plug and the drain plug. 5. Replace the return filter of the hydraulic system. Refer to "SERVICING THE RETURN FILTER". Service the suction strainer as described in "SERVICING THE SUCTION STRAINER". Service hydraulic reservoir filler strainer. DRESSTA TD-15H