DRESSTA Co. Ltd. TD-15H — 5.17.1. CHECKING THE OIL LEVEL

MAINTENANCE SECTION 5 Page 49 MOUNTED EQUIPMENT 5.15.5. Servicing the Ripper Prior to each day’s work carry out ripper inspection and remedy if any malfunction is found. Operating defective ripper results in reduced job efficiency and may cause its damage. The following table specifies services to be carried out during inspection: Replace a ripper shank point as follows: 1. Raise the ripper tooth about 300 [mm] above the ground and prop up to prevent the ripper tooth from lowering during service. 2. Stop the engine. 3. Remove the point mounting pin. 4. Install a new point and the mounting pin. 5.16. SAFETY BELT WARNING!

Seat belt – do not clean with solvents or bleach or re-dye color of webbing as this may cause a severe loss of strength. This could cause the webbing to break and result in personal injury. Wash in warm water with mild detergent. Keep the belt flat to avoid twisting and roping when not being used. Do not place heavy or sharp objects on the belt. The entire seat belt assembly should be inspected periodically for corrosion, wear, fraying or weak spots. The seat belt mounting bolts should also be periodically inspected for tightness. 5.17. FINAL DRIVES 5.17.1.

CHECKING THE OIL LEVEL Position the machine on level ground so that the "OIL LEVEL" mark on the final drive housing is positioned horizontally. Remove the magnetic filler and level plug, check the lubricant and, if the lubricant is low, fill to the level of the plug opening. Also, check the plug for metallic particles that may be present. If this condition continues after periodic checks, consult Authorized Distributor of Construction Equipment. Reinstall the plug and tighten. DRESSTA TD-15H POINT OF SERVICE SERVICE DESCRIPTION Ripper Assy Visually check for cracks, breakage, loose parts and completeness. Hydraulic hoses and connections Check for leaks and remedy, if any.

Hydraulic reservoir Check hydraulic reservoir oil level. Refer to Hydraulic System. Ripper pins Check if pins are secured correctly and tighten loosened bolts if necessary. Ripper shank point Check for wear. Replace, if the total length of the point is smaller than 160 [mm].