DRESSTA Co. Ltd. TD-15H — 5.19.4. CHECKING THE TENSION

SECTION 5 MAINTENANCE Page 56 UNDERCARRIAGE Clean mud and debris from the undercarriage so components can perform properly. WARNING! Special knowledge and equipment are required to service lubricated track systems and their components. Unless you are completely familiar with servicing lubricated track systems do not make any attempt to remove them. Disconnecting the master link could cause the chain to whip off the front idler causing serious personal injury. Improper track tension and loose track shoes will cause damage and premature wear to the track.

When new tracks or track shoes are installed, track tension and track shoe bolts should be checked after initial 10 hours of operation and adjusted if necessary. 5.19.2. TRACK SHOE BOLTS The bolts used for attaching the track shoes to the tracks are heat-treated alloy bolts and will stand a considerable tightening strain. Ordinary bolts must not be used. Nuts must be assembled so that washer face is not against track link. Radius side of nuts must be against track link. If removed or new, coat bolt threads and area under the head with engine oil. Torque value is given in Section 6. Check the bolts torque for 700 [Nm]. 5.19.3.

EFFECT OF TRACK ADJUSTMENT ON UNDERCARRIAGE WEAR Tracks adjusted too tightly increase operating loads on final drives and accelerate wear on undercarriage components, especially in packing conditions. A machine in forward operation with correctly adjusted tracks will experience track loads only along the ground from the front idler to where the bushings engage the sprocket. Lubricated track systems are to be adjusted to provide a sag in the track chain between the front top idler and the front idler. Correct tension reduces stress levels throughout the undercarriage system. 5.19.4. CHECKING THE TENSION 1. Place a wooden block, ~300 [mm] in height, under the foremost track shoe lug.

Drive the machine forward until the track chain is tight along the ground and around the sprocket. Apply and lock the brake pedal, lock the transmission shift lever in NEUTRAL position and stop the engine, turn the master switch off and remove the key. 2. Stand on the track between the front idler and the first track idler in order to accumulate all the chain slack at this point. 3. Place a straightedge on the track so the ends rest over the front idler and track idler. Measure the clearance between the bottom of the straightedge and the top of the shoe grouser with a ruler at the midway point between the idlers.

If the distance is more than 64 [mm] or less than 38 [mm] for lubricated chain and more than 38 [mm] or less than 25 [mm] respectively for non- lubricated chain, adjust the track tension. 4. For mud and snow packing conditions track should be adjusted so sag is 64 – 76 [mm] for lubricated chain and 38 - 50 [mm] for non-lubricated chain. TD-15H DRESSTA