MAINTENANCE SECTION 5 Page 57 UNDERCARRIAGE Fig. 5.52. Checking Track Tension 1. Track Sag of Lubricated Chain 2. Track Sag for Non-lubricated Chain 5.19.5. ADJUSTING TENSION The track chains are adjusted by hydraulic pressure. When lubricant is introduced into the front idler fork through the lubrication fitting, it acts upon the piston within the front idler fork forcing the front idler fork and front idler forward for track adjustment. WARNING! To avoid possible injury, always stand to the side of the bleeder plug when making track adjustment. The pressure in the front idler fork is held by the bleeder plug and check valve.
A loose or improper thread fit of either of these parts can allow them to be ejected by the pressure of lubricant, causing possible injury. When relieving track tension, never loosen the bleeder plug and check valve more than 2 – 2 Ѕ turns. 1. Remove the bolts and track adjuster cover. WARNING! Before adding lubricant for track adjustment, be sure the ball check and relief valves are properly torqued to 61 – 75 [Nm] . 2. To increase track tension, connect a lubricator nozzle to lubrication fitting (3). Determine the amount of adjustment necessary, and add lubricant to obtain the proper track chain tension.
It is advisable to move the machine forward and backward slightly to be sure the correct tension has been obtained. 3. To reduce track tension, loosen relief valve (2) Ѕ to 1 full turn to allow the pressurized lubricant to escape through the relief passage. If lubricant does not appear, loosen the ball check valve (located under lubricating fitting (3)) Ѕ to one full turn to allow the pressurized lubricant to escape from the second relief passage. DRESSTA TD-15H