SECTION 6 SPECIFICATIONS Page 10 SPECIAL TORQUES 6.5. TORQUES VALVES FOR STANDARD METRIC FASTENERS This chart provides tightening torque for general-purpose applications using original equipment standard hardware. Original equipment standard hardware is defined as coarse thread metric class 10.9 bolts and class 10.0 nuts and thru hardened flat washers (Rockwell "C" 38-45), all phosphate coated and assembled without supplemental lubrication (as received condition). The torques shown below apply to phosphate coated bolts designed for 60% yield strength.
The torques shown below also apply to phosphate coated bolts used with phosphate coated prevailing torque nuts, phosphate coated bolts used with copper plated weld nuts and are applied to steel and cast iron parts.
DRESSTA TD-15H No Description of tightening place Size of thread Torque [Nm] No of places 47 Diagonal Strut Cap Nut ¾ ["] 455 8 48 Lift Cylinder Cover Nut ¾ ["] 455 8 49 Track Roller Mounting Bolt ¾ ["] 455 All 50 Track Roller Shield and Rock Deflector Bushing Mounting Bolt ¾ ["] 455 All 51 Track Roller Shield and Rock Deflector Mounting Bolt ¾ ["] 455 All 52 Rear Track Idler Mounting Block Bolts ¾ ["] 455 8 53 Front Track Idler Mounting Block Bolt ¾ ["] 455 8 54 Front Idler Fork Mounting Bolt ¾ ["] 455 8 55 Track Shoe Bolt ¾ ["] 700 All 56 Sprocket Rock Shield Mounting Bolts ¾ ["] 455 8 57 Pivot Shaft Filler Plug ¾ ["] 20 – 54 2 58 Master Switch Mounting Nut ¾ ["] 51 1 59 Front Idler Shaft Support Bolt 7/8 ["] 730 4 60 Push Arm Trunnion Bolt 7/8 ["] 610 20 61 Rear Frame Drain Plug 7/8 ["] 48 – 62 3 62 Track Frame Guide Plate Mounting Bolt 7/8 ["] 730 12 63 FOPS/ROPS Mounting Bolt 1 ["] 1110 8 64 ROPS Support Mounting Bolt 1 ["] 1110 8 65 Track Frame Lower Guide Retainer Bolt 1 ["] 1110 4 66 Pusharm Trunnion Cap Bolt 1 ["] 1050 4 67 C-Frame Trunnion Cap Bolt 1 ["] 1050 4 68 Gimbal Crosstube Mounting Bolt 1 ["] 920 4 69 Track Frame Guide Retainer Bolt 1 ["] 1110 4 70 Push Arm Trunnion Bolt (LGP) 1 ["] 920 16 71 Ripper Mounting Frame Bolts 1-1/8 ["] 1300 16 72 Rigid Drawbar Mounting Bolt 1-1/8 ["] 1560 6