DRESSTA Co. Ltd. TD-15H — 4.17.4. FLOAT

SECTION 4 OPERATING Page 26 OPERATING MOUNTED EQUIPMENT Fig. 4.23. Blade Control Lever Positions (1) 1. Blade Control Lever 2. Ripper Control Lever 3. Horn Button I. Raise II. Hold III. Lower IV. Float V . LH Tilt VI. RH Tilt 4.17.1. HOLD When the lever is released from any position except “Float”, the lever automatically returns to the hold position. The blade height will remain the same, as it was when the lever was released. 4.17.2. RAISE Pull the control lever back to raise the blade to desired height. When released the lever will return to the hold position. 4.17.3. LOWER Push the control lever forward to lower the blade. When released the lever will return to the hold position. 4.17.4.

FLOAT With the control lever in the float position, the blade is free to follow the contour of the ground. To place the control lever in the float position, push all the way forward to its detented position in direction IV in Fig. 4.23. The lever will remain in this position until it is manually returned to the hold position. TD-15H DRESSTA