OPERATING SECTION 4 Page 27 OPERATING MOUNTED EQUIPMENT 4.17.5. TILT LH TILT Pull the control lever to the left to lower the left hand corner of the blade. The lever will return to the hold position when released. RH TILT Push the control lever to the right to lower the right hand corner of the blade. The lever will return to the hold position when released. 4.17.6. RIPPER CONTROL LEVER NOTE: For proper operation of the ripper control lever and observation of working tool it is necessary to swivel the operator’s seat 15° to the right. Fig. 4.24. Ripper Control Lever (2) 1. Blade Control Lever 2. Ripper Control Lever 3. Horn Button I. Ripper Raise II. Ripper Lower III. Hold 1.
Ripper Raise To raise the ripper to the required height, move the lever into position “I”. The control lever will return automatically to HOLD position “III” when released. 2. Ripper Lower To lower the ripper moves the lever into position “II”. The control lever will return automatically to HOLD position “III” when released. IMPORTANT: Holding the control lever in any position except HOLD for an extended period of time will produce excessive heat in the hydraulic system which may affect equipment performance. DRESSTA TD-15H