OPERATING SECTION 4 Page 29 OPERATING MOUNTED EQUIPMENT 4.17.7.3. LEVELLING THE BLADE WITH HYDRAULIC TILT 1. Place the lowest corner of the blade on a flat surface. 2. Move the control lever to this side to which the blade is to be lowered until the blade is even along the flat surface. NOTE: When venting the cylinders refer to “HYDRAULIC SYSTEM”. 4.17.7.4. PITCHING THE BLADE Fig. 4.26. Blade Pitch 1. Decreased suction angle for soft material. 2. Increased suction angle for hard materials. 3. Upper strut. 1. To pitch the blade forward (increasing suction angle), raise the blade several centimeters off the ground. Shut off the engine. Refer to “STOPPING THE ENGINE”.
Then extend upper struts (3) on each side of the blade an equal amount in the range of dimensions A given on Fig. 4.27. IMPORTANT: Do not expose any portion of the eyebolt threads. Fig. 4.27. Upper strut adjustment 2. To pitch the blade backward (decreasing suction angle), the upper strut must be shortened on each side of the blade an equal amount A given on Fig. 4.27. 3. After making the adjustments, secure the upper strut with the locking pin so it will not rotate. DRESSTA TD-15H