SECTION 4 OPERATING Page 30 OPERATING MOUNTED EQUIPMENT 4.17.8. ANGLING THE BULLDOZER BLADE 4.17.8.1. ADJUSTING THE DIAGONAL ANGLE OF BLADE. 1. Raise the blade off the ground and shut off the engine. Refer to section “STOPPING THE ENGINE” 2. Remove one strut trunnion from the trunnion bracket on the C-frame, keep it close to the C-frame. 3. Remove the strut trunnion from the trunnion bracket on the opposite side of the frame, and carefully swing the strut assembly out as far as it will go. WARNING! Stay clear of blade when performing above activities. Swinging the blade will cause lost of balance and a drop of the blade on the side of swung strut. 4.
Swing the first disconnected strut assembly outward to regain blade balance. Level the blade and maintain this level position while repositioning the blade (changing the angle). 5. Assemble the first strut assembly to the C-frame as follows: a) When connecting a blade angled to the right or the left, connect the rear most strut assembly first. b) When connecting a straight blade (not angled), swing each strut assembly in until they contact the C-frame, level the blade, then assemble either strut assembly. 6. Assemble the remaining strut assembly to the C-frame. If necessary, adjust the upper struts to obtain strut trunnion alignment with the trunnion brackets on the C-frame. 7.
Lock the strut trunnion in place through the C-frame bracket with lock pin chained to the lower strut. Loosen the clamping screws and nuts on the lower struts so that the strut eyebolt can be adjusted to fit into the swivel block. Fig. 4.28. Adjusting the Diagonal Angle of Blade TD-15H DRESSTA