SECTION 4 OPERATING Page 40 OPERATING TECHNIQUES 4.18.4. RIPPING 4.18.4.1. Prior to Operation Before operating the ripper proceed as follows: 1. Check all mounting hardware for torque. 2. Check the hydraulic connections for leaks. 3. Check the condition of the ripper, bits, mounting hardware for completeness and torque. 4.18.4.2. Ripping Techniques When starting ripping lower the ripper teeth slowly to the required depth. Ripping of rock material must be performed in direction of easier ripping which may be established by carrying out test ripping in various directions and under various angle of inclination of the shanks. During test ripping lower the shank to the half of working depth.
Machine efficiency can be improved when several centimeters of loose material is left on solid rock. Ripping should be performed at a depth the best results are obtained without overloading the engine. Keep loose ground level and horizontal as mach as possible. Never make turns with the machine with ripper teeth at full depth in rocky ground. Use common sense when working in hard ground not to damage the ripper and the machine. Do not accelerate the machine and simultaneously lower the ripper teeth into the ground – this will damage the ripper.
Pay attention not to allow the rear of the machine to lift off the ground during ripping operations, as this decreases traction and accelerates wear of track system. Use new and sharp bits for hard ground. 4.18.4.3. Cold Weather Operation Start the engine as described in “STARTING THE ENGINE” and then proceed as follows: move slightly and slowly ripper control to warm the oil in the hydraulic cylinders. raise the ripper at max. height and then lower it slowly until it rests on the ground. increase gradually pressure in the ripper cylinders by keeping the control lever in LOWER position until the rear of the machine is off the ground.
prior to normal ripping operations operate the ripper at low depth for a couple of minutes to warm the shank bits. protect the shank and bits when parking the machine. 4.19. ECONOMICAL OPERATION OF THE MACHINE Fuel consumption during operation of a dozer depends on many factors as: engine characteristics, load, terrain, operator’s skill and experience, the manner of operation. A relatively conclusive indicator of fuel consumption is the quantity on moved material per unit of consumed fuel. To reach the most favorable value of this ratio observe the following principles of dozer operation: Avoid long distance transporting of material.
Loading and pushing of material must be performed at gear which ensures maximum drawbar pull (1 st or 2 nd gear) with high blade fill ratio without loosing material in blade. Reverse travel at top gear but keep engine speed above medium, not maximum. Avoid stopping machine due to stall of the engine. Avoid track slippage. For digging hard material pitch the blade forward, for transportation of material pitch the blade backward. TD-15H DRESSTA