OPERATING SECTION 4 Page 39 OPERATING TECHNIQUES Fig. 4.45. Breaking Down a Pile Method 1 Method 2 1. Ramp 2. Original Slope When trucks or wagons are used for hauling, bulldozers are ideal spreading tools at the fill (Fig. 4.46). Blade should be kept in the straight position so that the material is drifted directly under the cutting edge (Fig. 4.47). When finishing in non-solid materials, such as earth, drag the blade backward for a smooth job as shown in Fig. 4.47. Rock, of course, may damage the blade base, therefore, such practice is not recommended where abrasive material is common. Fig. 4.46. Spreading Material Forward Fig. 4.47.
Back dragging Angling blade dozers are ideal for widening fills. Travel about 30 [cm] from the slope blind so that earth rolling off the blade end will fall over the edge as shown in Fig. 4.48. Fig. 4.48. Widening a Fill DRESSTA TD-15H