OPERATING THE TRANSMISSION vehicle start forward, until the clutch is fully engaged. See the manufacturer's Driver/Operator's Instruction Manual for further details. During Normal Driving Double Clutching If you want to shift directly into any gear other than first or reverse, depress the clutch pedal only far enough to release the clutch. Fully pressing the pedal applies the clutch brake and could cause gear hang-up. Whether you are upshifting or down shifting, it is best to double clutch. Double clutching is easier on the transmission and on the engine, helping your vehicle match engine speed with driveline speed and achieving clash-free shifts.
If the transmission has a butt-tooth condition and you cannot engage a gear, gradually release the clutch. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. CAUTION Be careful not to apply the clutch brake while the vehicle is moving. The purpose of the clutch brake is to stop the transmission so that you can shift into a starting gear without grinding gears. Applying the clutch brake when the vehicle is moving will render the clutch inoperative. To double clutch: 1. Push the clutch pedal down to disengage the clutch. 4 2. Move the gear shift lever to neutral. 3. Release the pedal to engage the clutch.
This lets you control the RPM of the mainshaft gears, allowing you to match the RPM of the mainshaft gears to those of the output shaft. a. Upshifts: let the engine and gears slow down to the RPM required for the next gear. (03/17) Y53-6076-1B1 4-17