Peterbilt Conventional Truck Series — Vehicle Recovery Guidelines

VEHICLE RECOVERY AND SPRING BRAKES Recovery Hitch Installation Driver Controlled Main Differential Use the following procedure to install the Vehicle Recovery Hitches. See Recovery Hitch Assembly illustration for part identification. Follow these steps to lock a driver-controlled main differential. 2 WARNING! 1. Check square sockets behind lower bumper for obstructions, clear if necessary. An open air line on the recovered vehicle will cause a leak in the air system of the recovery vehicle if both vehicles’ brake systems are connected.

This could cause a loss of system air, which can cause the service brakes not to function, re- sulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles. You could be in an accident involving death or personal injury. Ensure that any air line that has been removed from a driver-controlled main differential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. 2. With lock pins removed, insert hitches through bumper and into the square hitch socket. 3. Align the hole in the tow hitch with the square hitch socket hole. Driver Controlled Main Differential Lock 4.

Insert the lock pin into the square hitch socket hole and through the hole in the tow hitch until the lock tab is within the square hitch socket. 1 Air Line (remove to install Caging Bolt) 2 Caging Bolt (in storage location) 5. Rotate the lock pin 90 degrees to secure the pin in place. 1. Lift driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle. 6. Remove the hitches and store all parts after recovering the vehicle. 2-18 Y53-6076-1B1 (03/17)